DURAG D-LX101UA-30 Flexible Compact Flame Monitor

Benefits
Easy access to the available settings reduces the time required for commissioning
Choice of the available detectors allows the monitoring of flames of all fuels within the same device family
The same device technology can be used for plants in the most varied regions and on the basis of a wide range of systems of standards
If the requirements for the plant change (Ex zones, need for fibre optic systems) exchange within the device family is usually possible
The ability to adjust the settings outside the factory allows prompt exchange with smaller local stocks of replacement devices are low

Aplicação
Simple combustion plants with single burners or optically separated burners
Combustion processes in continuous operation

Especificações
Spectral sensitivity UV, VIS, IR
Operating mode Intermittent operation and continuous operation
Functional Safety Self-monitoring and fail-safe, supports safety chains up to SIL 3
Switching threshold Flame intensity
Local display LEDs – always visible at a single glance for all versions
Flame failure detection time (FFDT) 0.5 … 5 s (in steps of 0.5 s)
Flame ON/OFF contacts 1x NO contact, 1x NC contact
Ready for operation contact 1x NO contact
Switching capacity of relay contacts Max. 24 VDC, 250 VAC
Analogue output 0/4 … 20 mA (selectable), load max. 750 Ohm
Electrical data 24 VDC, 7 W, PELV
Ambient conditions -40 … +75 °C
-40 … +70 °C (variant UL)